Proceedings
Authors
| Filter results20 paper(s) found. |
|---|
1. Study on Monitoring System of Wheat SowingIn order to real-time monitoring the sowing status of the multi-channel seeder, a distributed monitoring system is developed. The monitoring module of sowing and the monitoring terminal is designed with ... W. Fu, Z. Meng, G. Wu, J. Dong, H. Mei, C. Zhao |
2. Spatial Variability of Inceptisol and Entisol Soils and Their Effect on Merlot Grape Must CompositionTechnologies associated to precision agriculture are being used in some crops in Brazil, mainly soybean, wheat, corn and sugarcane. However, information on its use in viticulture is scarce. Thus, a research was carried out during the vegetative cycle of 2010/2011 in a clone 347 Merlot... C. Flores, J. Filippini a., A. Miele |
3. The Spatial And Temporal Variability Analysis Of Wheat Yield in suburban of BeijingAbstract: The yield map is the basis of the fertilization maps and plant maps. In order to diagnose the cause of variation accurately, not only the spatial variation of annual yield data, but also the successive annual yield data of temporal variability should be understood.The introduction of yield monitor system, global positioning system (GPS), and geographic information system have provided new methods to obtain wheat yield in precision agriculture.... Z. Meng, Z. Wang, G. Wu, W. Fu, X. An |
4. Spatial-temporal Evaluation of Plant Phenotypic Traits Via Imagery Collected by Unmanned Aerial Systems (UAS)Unmanned aerial systems (UAS) and a stereovision approach were implemented to generate a 3D reconstruction of the top of the canopy. The 3D reconstruction or CSM (crop surface model) was utilized to evaluate biophysical parameters for both spatial- and temporal-scales. The main goal of the project was to evaluate sUAVs technology to assist plant height and biomass estimation. The main outcome of this process was to utilize CSMs to gain insights in the spatial-temporal dynamic of plants within... S. Varela, G. Balboa, V. Prasad, T. Griffin, I. Ciampitti, A. Ferguson |
5. The Device of Air-assisted Side Deep Precision Fertilization for Rice TransplanterRice is the most important crop in China, which has the largest plant area. Fertilization is an important process of rice production, which directly affects the yield of crops, reasonable and effective use of chemical fertilizer can improve the yield of crops. At present, the mechanization level of rice fertilization is very low in China, and the artificial fertilization requires a large amount of fertilizer which caused the uneven distribution. The rice side deep fertilizing is an ideal way of... C. Zhao, G. Wu, Z. Meng, W. Fu, L. Li, X. Wei |
6. Development of Land Leveling Equipment Based on GNSSAn attitude adjustable land leveling equipment was designed. The reference elevation of the land to be leveled was generated based on the topographic data which was acquired by the RTK-GNSS technology. The blade lifting mechanism was controlled by comparing the reference elevation and the real-time blade’s elevation and attitude data which was obtained by the dual antenna GNSS receiver and as a result the land leveling operation was implemented. A new algorithm using the electro-hydraulic... W. Fu, G. Wu, H. Bao, X. Wei, Z. Meng |
7. Evaluating low-cost Lidar and Active Optical Sensors for pasture and forage biomass assessmentAccurate and reliable assessment of pasture or forage biomass remains one of the key challenges for grazing industries. Livestock managers require accurate estimates of the grassland biomass available over their farm to enable optimal stocking rate decisions. This paper reports on our investigations into the potential application of affordable Lidar (Light Detection and Ranging) systems and Active Optical (reflectance) Sensors (AOS) to estimate pasture biomass. We evaluated the calibration accuracy... M. Trotter, K. Andersson, M. Welch, M. Chau, L. Frizzel, D. Schneider |
8. Spatial-temporal Evaluation of Plant Phenotypic Traits Via Imagery Collected by Unmanned Aerial Systems (UAS)Unmanned aerial systems (UAS) and a stereovision approach were implemented to generate a 3D reconstruction of the top of the canopy. The 3D reconstruction or CSM (crop surface model) was utilized to evaluate biophysical parameters for both spatial- and temporal-scales. The main goal of the project was to evaluate sUAVs technology to assist plant height and biomass estimation. The main outcome of this process was to utilize CSMs to gain insights in the spatial-temporal dynamic of plants within... S. Varela, G. Balboa, V. Prasad, T. Griffin, I. Ciampitti, A. Ferguson |
9. Effective Use of a Debris Cleaning Brush for Mechanical Wild Blueberry HarvestingWild blueberries are an important horticultural crop native to northeastern North America. Management of wild blueberry fields has improved over the past decade causing increased plant density and leaf foliage. The majority of wild blueberry fields are picked mechanically using tractor mounted harvesters with 16 rotating rakes that gently comb through the plants. The extra foliage has made it more difficult for the cleaning brush to remove unwanted debris (leaf, stems, weeds, etc.) from the picker... K. Esau, Q. Zaman, A. Farooque, A. Schumann |
10. An Automatic Control Method Research for 9YG-1.2 Large Round BalerWhen manual or semi-automatic round baler working, the tractor driver have to frequently manual the machine according to the bale process at the same time of driving. The driver easily feel fatigue in this operating mode for a long time, so the consistency of the bale’s density can not be guaranteed. And there may be wrong operation. In this article, we use the model 9YG-1.2 large round baler as a research prototype. We study the information collection and processing of the baler’s... J. Dong, Z. Meng, Y. Cong, A. Zhang, W. Fu, R. Pan, Q. Yang, Y. Shang |
11. Development of Farmland-Terrain Simulation System for Consistency of Seeding DepthA farmland-terrain simulation system suitable for rugged topography was designed to study the irregularities of farmland surface morphology led by both topographic fluctuation and terrain tilt. The system consists of terrain simulation mechanism, hydraulic system, control system, etc. The terrain simulation mechanism is connected to the rack through hydraulic cylinder to simulate farmland surface fluctuation. The hydraulic system controls the hydraulic cylinder to drive the terrain simulation... W. Fu, J. Dong, Y. Cong, N. Gao, Y. Li, Z. Meng |
12. Design of Ground Surface Sensing Using RADARGround sensing is the key task in harvesting head control system. Real time sensing of field topography under vegetation canopy is very challenging task in wild blueberry cropping system. This paper presents the design of an ultra-wide band RADAR sensing, scanning device to recognize the soil surface level under the canopy structure. Requirements for software and hardware were considered to determine the usability of the ultra-wide band RADAR system.An automated head elevation... M.M. Mohamed, Q. Zaman, T. Esau, A. Farooque |
13. Variable Rate Fertilization in a High-yielding Vineyard of Cv. Trebbiano Romagnolo May Reduce Nitrogen Application and Vigour Variability Without Loss of Crop LoadThe site-specific management of vineyard cultural practices may reduce the spatial variability of vine vigor, contributing to achieve the desired yield and grape composition. In this framework, variable rate fertilization may effectively contribute to reduce the different availability of mineral nutrients between different areas of the vineyard, and so achieving the vine’s aforementioned performances. The present study was aimed to apply a variable rate fertilization in a high-yielding... G. Allegro, R. Martelli, G. Valentini, C. Pastore, R. Mazzoleni, F. Pezzi, I. Filippetti, A. Ali |
14. Integration of High Resolution Multitemporal Satellite Imagery for Improving Agricultural Crop Classification: a Case StudyTimely and accurate agriculture information is vital for ensuring global food security. Satellite imagery has already been proved as a reliable tool for remote crop mapping. Planet satellite imagery provides high cadence, global satellite coverage with higher temporal and spatial resolution than the Landsat-8 and Sentinel-2. This study examined the potential of utilizing high-resolution multitemporal imagery along with and normalized difference vegetation index (NDVI) to map the agricultural crops... U. Ali, T. Esau, A. Farooque, Q. Zaman |
15. A Framework for Imputation of Missing Parts in UAV Orthomosaics Using Planetscope and Sentinel-2 DataIn recent years, the emergence of Unmanned Aerial Vehicles (UAV), also known as drones, with high spatial resolution, has broadened the application of remote sensing in agriculture. However, UAV images commonly have specific problems with missing areas due to drone flight restrictions. Data mining techniques for imputing missing data is an activity often demanded in several fields of science. In this context, this research used the same approach to predict missing parts on orthomosaics obtained... F.R. Pereira, A.A. Dos reis, R.G. Freitas, S.R. Oliveira, L.R. Amaral, G.K. Figueiredo, J.F. Antunes, R.A. Lamparelli, E. Moro, N.D. Pereira, P.S. Magalhães |
16. Suitability of ML Algorithms to Predict Wild Blueberry Harvesting LossesThe production of wild blueberries (Vaccinium angustifolium.) is contributing 112.2 million dollars to the Canada’s revenue which can be further increased through controlling harvest losses. A precise prediction of blueberry harvesting losses is necessary to mitigate such losses. In this study, the performance of three machine learning (ML) models was evaluated to predict the wild blueberry harvest losses on the ground. The data from four commercial fields in Atlantic Canada were... H. Khan, T. Esau, A. Farooque, F. Abbas |
17. Nitrogen Status Prediction on Pasture Fields Can Be Reached Using Visible Light UAV Data Combined with Sentinel-2 ImageryPasture fields under integrated crop-livestock system usually receive low or no nitrogen fertilization rates, since the expectation is that nitrogen demand will be provided by the soybean remaining straw cropped previously. However, keeping nitrogen at suitable levels in the entire field is the key to achieving sustainability in agricultural production systems. In this sense, remote sensing technologies play an essential role in nitrogen monitoring in pastures and crops. With the launch of the... F.R. Pereira, J.P. Lima, R.G. Freitas, A.A. Dos reis, L.R. Amaral, G.K. Figueiredo, R.A. Lamparelli, J.C. Pereira, P.S. Magalhães |
18. Management Zone-specific N Mineralization Rate Estimation in Unamended SoilSince nitrogen (N) mineralization from soil organic matter is governed by basic soil properties (soil organic matter content, pH, soil texture, …) that are known to exhibit strong in-field spatial variability, N mineralization is also expected to exhibit significant spatial variability at field scale. An ideal and efficient N recommendation for precision fertilization should therefore account for potential soil mineralizable N considering this spatial variability. Therefore, this study... F.Y. Ruma, M.A. Munnaf, S. De neve, A.M. Mouazen |
19. Enhancing Precision Agriculture with Cosmic-ray Neutron Sensing: Monitoring Soil Moisture Dynamics and Its Impact on Grapevine PhysiologyPrecision agriculture has emerged as a transformative approach in modern viticulture, seeking to optimize vineyard management. Vineyard operations rely heavily on effective water management, especially in regions where water availability can significantly affect grape quality and yield. The relationship between soil moisture and grapevine physiology is however complex. Therefore, understanding these relationships is crucial for optimizing vineyard operations. Cosmic-ray neutron sensing (CRNS)... R. Mazzoleni, F. Vinzio, S. Emamalizadeh, G. Allegro, I. Filippetti, G. Baroni |
20. Application of Advanced Soft Computing to Estimate Potato Tuber Yield: a Case Study from Atlantic CanadaThe potato crop plays a crucial role in the economy of Atlantic Canada, particularly in Prince Edward Island and New Brunswick, where it contributes significantly to potato production. To help farmers make informed decisions for sustainable and profitable farming, this study was conducted to examine the variations in potato tuber yield based on thirty soil properties collected over four growing seasons through experimental trials. The study employed an advanced and explainable ensemble model called... Q.U. Zaman, A. Farooque, M. Jamei, T.J. Esau |